Installation - Husky 45202 Use And Care Manual

Installation

1
Select the location for your Husky Track Wall Panels
□ Both the left and right sides of Husky Track Wall Panels should fasten into studs.
□ Husky Track Wall Panels are 48.5 in. height (when assembled). Select the desired elevation at which to begin assembly of your
Husky Track wall Panels and mark a horizontal level line at which to start from the bottom.
NOTE: In order to support 75 lbs per square
foot, your studs must be a maximum of 16 in. apart.
48.5 in.
2
Locate and mark studs
□ Once you have chosen your installation location,
verify that you are starting and finishing on a stud.
□ Using a stud finder, locate all studs between start and
finish, and mark along their length with a level. You will
need to screw each panel into each stud.
?
?
96 in.
16 in.
3
Fasten horizontal J-trim to the wall
NOTE: For this step, it is best to have the help
of a second person.
□ Use snips to cut one J-trim (B) to a lengh of 96 in.
□ Install the bottom horizontal 96 in. J-trim where you
marked your level line, using screws (BB), fastening the
widest edge to the wall. Do not fasten into the first or last
stud..
front side
wall side
B J-trim
5
Please contact 1-888-HD-HUSKY for further assistance.
96 in.
x 5
HUSKYTOOLS.COM