Maintenance - Dimplex CS-1205 Owner's Manual

Maintenance

WARNING: Disconnect power
before attempting any main-
tenance or cleaning to reduce
the risk of fire, electric shock or
damage to persons.
Light Bulb Replacement
Allow at least five minutes for the
light bulb to cool off before touch-
ing, to avoid accidental burning
of the skin. The light bulb needs
to be replaced when you notice a
dark section of the flame or when
the clarity and detail of the log
exterior disappears. There is one
bulb located at the back of the
unit behind the access panel.
Light Bulb Requirement: Quan-
tity of one clear chandelier or can-
delabra bulb with an E-12 (small)
socket base, and 60 Watt rating.
To Replace the Bulb (Figure 2)
1. Remove the five Phillips
screws from the access panel,
located on the back of the unit,
and remove access panel.
2. Locate and examine the bulb
to determine if replacement is
required.
3. Unscrew the bulb counter
clockwise.
4. Insert and install new bulb.
5. Secure access panel to unit.
8
Figure 2
Access Panel
Clear Door Panel Cleaning
The clear door is cleaned in the
factory during the assembly op-
eration. During shipment, installa-
tion, handling, etc., the clear door
may collect dust particles. These
can be removed by dusting lightly
with a clean, dry cloth.
To remove fingerprints or other
marks, the clear doors can be
cleaned with a damp cloth. The
clear door should be completely
dried with a lint free cloth to
prevent water spots. To prevent
scratching, do not use abrasive
cleaners or spray liquids on the
clear door surface.
Bulb
Screws
(5)
www.dimplex.com