Safety Area Detection; Shutter Close Detection - Canon STAPLER STACKER SS-72 Service Manual

D. Safety Area Detection Switch
1) Following the rear cover removal proce-
dure described on Page 3-4, remove the
rear cover.
2) Remove the screw, disconnect the con-
nector, and then take out the safety
area detection switch.
Screw
Connector
Safety area detection switch
Figure 3-5-5
E. Shutter Close Detection Switch
1) Following the bottom guide removal
procedure described on Page 3-5,
remove the bottom guide.
2) After taking out the cable from the cable
clamp, remove the 2 screws and then
the shutter close detection switch.
Cable clamp
Cable
Screws
Shutter close detection switch
Figure 3-5-6
CHAPTER 3
3 - 13