Table of Contents
Advertisement
INSTALLATION CONSIDERATIONS
This section of the Service Handbook covers some of the critical installation requirements that, when
overlooked, often result in operational problems, down time and needless parts replacement. Costs to
correct installation errors are not covered under the limited warranty. Ensure all installation requirements and
instructions contained in the Instruction Manual that came with the water heater have been followed prior to
performing any service procedures.
INSTRUCTION MANUAL
Have a copy of the Instruction Manual that came with the water heater on hand for the model and series
number being serviced. Installation information given in this Service Handbook is not a complete installation
instruction. Installation information given in this Service Handbook has a limited focus as it applies to servicing
the water heater. This Service Handbook does not replace or supersede the Instruction Manual that came
with the water heater. Always refer to the Instruction Manual for complete installation instructions. If the
Instruction Manual is not on hand, copies can be obtained from the manufacturers web site or by calling the
technical support phone number shown on the back cover of this Service Handbook.
CLOSED WATER SYSTEMS
Water supply systems may, because of code requirements or such conditions as high line pressure, among
others, have installed devices such as pressure reducing valves, check valves, and back fl ow preventers.
Devices such as these cause the water system to be a closed system.
THERMAL EXPANSION
As water is heated, it expands (thermal expansion). In a closed system the volume of water will grow when
it is heated. As the volume of water grows there will be a corresponding increase in water pressure due to
thermal expansion. Thermal expansion can cause premature tank failure (leakage). This type of failure is not
covered under the limited warranty. Thermal expansion can also cause intermittent Temperature-Pressure
Relief Valve operation: water discharged from the valve due to excessive pressure build up. This condition
is not covered under the limited warranty. The Temperature-Pressure Relief Valve is not intended for the
constant relief of thermal expansion.
A properly sized thermal expansion tank must be installed on all closed systems to control the harmful effects
of thermal expansion. Contact a local plumbing service agency to have a thermal expansion tank installed.
AIR REQUIREMENTS
Carefully review the requirements for combustion and ventilation air in the Instruction Manual that came
with the water heater. Failure to meet these requirements when the water heater is installed or overlooking
their importance when servicing the water heater often results in needless down time, unnecessary parts
replacement, and customer dissatisfaction.
An inadequate supply of air for combustion and ventilation often causes operational problems. A lack of
combustion and ventilation air can create a negative ambient air pressure in the installed space which can
lead to improper combustion and operational problems with pressure switches.
CONTAMINATED AIR
Combustion air that is contaminated can greatly diminish the life span of the water heater and water heater
components such as Igniters and Burners. Propellants of aerosol sprays, beauty shop supplies, water softener
chemicals and chemicals used in dry cleaning processes that are present in the combustion, ventilation or
ambient air can cause such damage.
Vapors from volatile compounds such as solvents, cleaners, chlorine based chemicals and refrigerants in
addition to being highly fl ammable in many cases, can also react to form highly corrosive substances such
as acids inside the combustion chamber. The results can be hazardous and cause product failure.
If the water heater is installed in beauty shops, barber shops or laundries with dry cleaning equipment, it is
imperative the water heater be installed in a Direct Vent confi guration so that air for combustion is derived
directly from the outdoor atmosphere through a sealed intake air pipe. See the venting installation section
in the Instruction Manual that came with the water heater for more information on Direct Vent installations.
Servicing should only be performed by a Qualifi ed Service Technician
3
Advertisement
Table of Contents
Troubleshooting
