Sony LocationFree LF-B10 Operating Instructions Manual page 67

Video
Problem
No color, poor color.
Picture appears but there is no sound.
No picture.
Distorted color.
Picture freezes frequently.
Block noise appears.
When you change the rate, video is not
smooth.
Compared with usual, the video or
sound quality gets worse.
Picture is distorted.
Disconnected when switching to another
rate.
The actual video rate varies from the rate
set on the Customize Change Rate
screen.
When operating the on-screen remote
control, fast-forward occurs.
No picture from the connected device.
Causes and remedies
Make sure the A/V cable is connected properly to the Base Station.
• Make sure the volume of LocationFree Player is not turned all the way
down.
• Make sure the volume of the computer is not set to the minimum level
or mute.
Check the causes and remedies described in "Watching Video at Home"
(1 page 28) or "Watching Video Away from Home" (1 page 28).
Update the graphics driver of your computer to the latest version. For
more information on the graphics driver, contact the manufacturer of your
computer.
• Depending on your network, check the causes and remedies described
in "Watching Video at Home" (1 page 28) or "Watching Video Away
from Home" (1 page 28).
• When the rate is too high for the actual speed of your connection, delay
is even more likely to occur. Set the rate to [Auto] or lower the rate
(1 page 13).
This is due to video compression processing. It is not a malfunction.
It is because of video compression, not a breakdown.
Disconnect the connection to the Base Station and connect it again.
Check the latest driver of the video card (graphic card) on the
manufacturer's support pages.
When you change the video rate, the connection between the computer
and the Base Station may be disconnected and then reconnected in some
situation (1 page 13). This is not a malfunction.
The settings you make are only approximate point values and the actual
video rate may vary from the settings. Some video content may make the
video rate higher.
For faster response to the on-screen remote control, fast-forward may
occur. This is not a malfunction.
• Firmly attach the connection cables. Check that the connections to the
red, white and yellow jacks are correct.
• Non-interlaced signals from computers or other equipment cannot be
displayed.
• Make sure the device is connected to the correct input terminal.
• If you connect your device to the output terminal instead of the input
terminal of the Base Station, you cannot watch video from the device.
Connect it to the input terminal.
• Make sure that the power of the video device is on.
27