Test/Service Switch - Bunn CDS-2 Operating & Service Manual

For cds-2 & 3
Hide thumbs Also See for CDS-2:
Table of Contents

Advertisement

SERVICE (cont.)

TEST/SERVICE SWITCH

FIG. 13 TEST/SERVICE SWITCH
Location:
The TEST/SERVICE switch is located on the
left front of the whipper motor mounting panel.
Test Procedure:
1. Disconnect the dispenser from the power
source.
2. Disconnect the wires from the switch terminals.
3. Check for continuity between the center terminal
and upper terminal with switch in the SERVICE
position (lower). Check for continuity between
the center terminal and the lower terminal with
the switch in the TEST position (upper). Continu-
ity must not be present when the switch is in the
center position.
If continuity is present as described, the switch is
operating properly.
If continuity is not present as described, replace the
switch.
Removal and Replacement:
1. Disconnect the dispenser from the power source.
2. Open the dispenser door and remove the hopper
assembly out the front of the dispenser.
3. Remove the four #8-32 screws securing the hopper
support panel to the auger motor mounting panel
and the whipper motor mounting panel.
4. Slowly lift the hopper support panel up and discon-
nect the red/black and green wires from the hopper
switch.
5. Remove the facenut securing the TEST/SERVICE
switch the whipper motor mounting panel.
6. Remove switch with wires attached from the back
side of the whipper motor mounting panel.
7. Disconnect the wires from the switch and discard
the switch.
8. Refer to Fig. 14 when connecting the wires to the
P1923
new switch.
9. Install new switch with wires attached through the
hole in the whipper mounting panel and secure with
facenut.
10. Connect the red/black and green wires to the hopper
switch. See Fig. 10 on page 17.
11. Install the hopper support panel to the auger motor
mounting panel and the whipper motor mounting
panel using the four #8-32 screws.
12. Install the hopper assembly.
WHI/ORN from Control
Board J1-6
GRN from Control
Board J1-8
BLU/BLK from Control
Board J1-11
FIG. 14 TEST/SERVICE SWITCH
21
TERMINALS
P1906
29793 061599

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cds-3Powder auto fill

Table of Contents