Table of Contents
Advertisement
ESC/Motor Wiring Diagram
12 • DRAG SLASH
TRAXXAS TQ
RADIO & VELINEON POWER SYSTEM
i
Your model is equipped with the newest TQi 2.4GHz transmitter
™
with Traxxas Link
Model Memory. The transmitter has two
channels for controlling your throttle and steering. The receiver
inside the model has 5 output channels. Your model is equipped
with one servo and an electronic speed control.
TRANSMITTER AND RECEIVER
Set Button
Red/Green Status LED
see page 29 for more info
Menu Button
Steering
Trim
Multi-Function
Knob
Trans Brake
Throttle
Trigger
Link
Button
Power Switch
Battery Compartment
**Accessory sensor port for use with the Telemetry
Expander Module (see Traxxas.com for more information).
MODEL WIRING DIAGRAM
Steering Wheel
Antenna
VXL-3s ELECTRONIC SPEED CONTROL
Traxxas High-Current
Connector (Male)
Sensor Expansion
to Battery
Port
**
Cooling Fan
Connector
(for optional use)
LED
Receiver cable
(RX wire)
LED
Channel 1
Steering Servo
Traxxas High-Current
Connector (Male)
to Battery
Cooling Fan
Connector
(for optional use)
V/T - Voltage/Temp Sensor Port
†
Channel 2
RPM - RPM Sensor Port
†
Electronic Speed Control
BATT/
CH5 - Battery/Channel 5*
CH4 - Channel 4*
CH3 - Channel 3*
CH2 - Speed Control
CH1 - Steering Servo
CH1 - Channel 1*
†
*Not used
Accessory sensor ports for use with standard voltage/temperature and RPM
telemetry sensors (see Traxxas.com and included materials for more information)
EZ-Set Button
(On/Off Button)
Brushless Motor
(see sidebar for proper
motor wiring)
Motor Cap
to Motor
Heat Sink
Advertisement
Table of Contents
