Table of Contents
Advertisement
TROUBLESHOOTING
Your dishwasher may not work properly.
Before contacting the Service Centre check if the problem can be solved by going through the following list.
PROBLEMS
POSSIBLE CAUSES
The dishwasher
The appliance has not been plugged in
won't start
properly.
or does not
Power outage.
respond to com-
mands.
The dishwasher door is not closed.
It does not respond to commands.
The dishwasher
The wash cycle has not fi nished yet.
won't drain.
The drain hose is bent.
The sink drain pipe is blocked.
The fi lter is clogged up with food residues.
The dishwasher
The dishes are rattling against each
makes
excessive noise.
An excessive amount of foam has been
produced.
The dishes are
The crockery has not been arranged
not clean.
properly.
The spray arms cannot rotate freely, being
hindered by the dishes.
The wash cycle is too gentle.
An excessive amount of foam has been
produced.
The cap on the rinse aid compartment has
not been shut correctly.
The fi lter is soiled or clogged.
There is no salt.
MAINTENANCE AND TROUBLESHOOTING GUIDE
For more information, maintenance procedures and troubleshooting,
see the Use and Care Guide
The Use and Care Guide can be obtained by:
• After-Sales Service; phone number see in warranty booklet.
• download from website: docs.whirlpool.eu
• use QR code
TECHNICAL DATASHEET
The technical data containing the energy consumption data can be
downloaded from the website: docs.whirlpool.eu
8
SOLUTIONS
Insert the plug into the socket.
The dishwasher starts automatically when the power returns.
Vigorously push the door until you hear the "click".
Switch off the appliance by pressing the ON/OFF button, switch it back on
after approximately one minute and reset the program.
Wait until the wash cycle fi nishes.
Check that the drain hose is not bent (see INSTALATION INSTRUCTION).
Clean the sink drain pipe.
Clean the fi lter (see CLEANING THE FILTER ASSEMBLY).
Position the crockery correctly (see LOADING THE RACKS).
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see FILLING THE DETERGENT DISPENSER). Reset dishwa-
sher by pressing the DRAIN button (see OPTIONS AND FUNCTIONS) and run
new program without detergent.
Arrange the crockery correctly (see LOADING THE RACKS).
Arrange the crockery correctly (see LOADING THE RACKS).
Select an appropriate wash cycle (see PROGRAMS TABLE).
The detergent has not been measured out correctly or it is not suitable for use
in dishwashers (see FILLING THE DETERGENT DISPENSER).
Make sure the cap of the rinse aid dispenser is closed.
Clean the fi lter assembly (see CARE AND MAINTENANCE).
Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
CONTACTING AFTER-SALES SERVICE
When you contact the After-Sales Service,
you must provide the codes shown on the
rating plate attached to the left or right side
inside the door of the dishwasher. The pho-
ne number is listed in the warranty booklet
or on the website: www.whirlpool.eu
IEC 436
:
400011317745
10/2018 mk - Xerox Fabriano
Advertisement
Table of Contents
