Taking Weight And Body Fat Readings; Programming The Guest Mode - Tanita UM-051 Instruction Manual

GB

TAKING WEIGHT AND BODY FAT READINGS

SET
MEMORY
GUEST

PROGRAMMING THE GUEST MODE

SET
MEMORY
GUEST
TAKING WEIGHT MEASUREMENT ONLY
SET
MEMORY
GUEST
7
After programming your personal data you are ready to take a reading.
1. Select Personal Data Number
OFF
Press the Up button turn on. Use the Up/Down buttons to select your
Personal data number. Press the Set button to confirm.
(Release the key within 3 seconds or the display will show "Error".)
The unit will beep and the display will show the programmed data.
The unit will beep again and the display will show "0.0".
Now step onto the platform.
Note:
•If you step onto the platform before "0.0" appears the display will show "Error" and you will
not obtain a reading. Furthermore, if you do not step onto the measuring platform within
about 30 seconds after "0.0" appears, the power is shut-off automatically.
•When using the "Up" button to turn the unit on, the personal data number last used will
appear first.
•Numbers that are not pre-programmed are automatically skipped.
2. Get Your Readings
Your weight will be shown first.
Continue to stand on the platform.
"00000" will appear on the display and disappear one by one from left to
right.
The display will then flash your %TBW, weight and %FAT alternately 3 times.
Note: Do not step off until Body Fat % is shown.
The Guest mode allows you to use the monitor without losing the
information already assigned to a Personal Data Number.
To program the Guest mode, use the Down button marked with a "G" to turn
on the power. Then follow steps 3 through 5 in "
" (p.6.) The unit will beep twice and the display will show "0.0".
Memory
Step onto the platform. Next follow the directions for "Get Your Reading"
(p.7).
OFF
Note: If you step onto the platform before "0.0" appears the display will show "Error" and
you will not obtain a reading.
Select Weight-Only Mode
OFF
Using your toe, tap the Weight-only key. After 2 or 3 seconds, "0.0" will
appear in the display and the unit will beep. When "0.0" appears in the
display, step onto the platform. The body weight value will appear. If you
remain on the platform, the display will flash for about 30 seconds, and then the power
will automatically turn off. If you step off the platform, the weight will continue to show for
about 5 seconds, then "0.0" will appear and the unit will shut off automatically.
Setting and Storing Data in