Sony DR-EX13DPV Operating Instructions

Stereo
Headset
DR-EX13DPV
©2010 Sony Corporation Printed in Thailand





S
2 lines

Sectional View
Colored parts


4-270-281-41(1)
Operating Instructions
Manual de instrucciones
Microphone
To headphone jack
To microphone jack (pink)
Volume control
M L
3 lines

English
Stereo headset
Features
 Hands free headset for laptop PC with headphone and microphone plugs.
 Hybrid silicone rubber earbuds (S, M, L) supplied for secure fitting and long-term
wearing comfort.
 Talk hands-free with in-line microphone.
 Plug rest structure for headphones usage (storage for microphone plug).
 Easy-to-use in-line volume control.
 Practical 1.2 m cord for laptop PC use.
Supported PC models
 IBM PC/AT or compatible computer with a microphone input jack and a sound
output jack, or a computer with a built-in sound card.
 It is required that the sound card has a power supply for the microphone.
 It is required that the microphone input jack and sound output jack are aligned.
 This is not compatible with Macintosh computers.
How to use
1
Connect the headphone plug to the headphone jack and connect the
microphone plug (pink) to the microphone jack (see fig. ).
2
Wear the headset marked  on your right ear, and the one marked  on
your left ear.
There is a tactile dot on the unit marked  to distinguish the left side.
Adjusting the volume level of the microphone
Check and adjust the volume level of the microphone by the computer. For details on the
operation of your computer, refer to the operating instructions of your computer.
Volume control (see fig. )
Rotate upward to increase the volume and rotate downward to decrease the volume.
When you do not use the microphone plug (see fig. )
When listening to a "WALKMAN, " etc., but not using the microphone, you can insert the
microphone plug into the plug holder attached to the headphone plug so that it does not
dangle.
Installing the earbuds correctly (see fig. )
If the earbuds do not fit your ears correctly, low-bass sound may not be heard. To enjoy
better sound quality, change the earbuds to another size, or adjust the earbuds position to
sit on your ears comfortably and fit your ears snugly.
If the earbuds do not fit your ears, try another size. When you change the earbuds, install
them firmly on headset to prevent the earbud from detaching and remaining in your ear.
To check the transparent earbud sizes
The transparent earbud sizes are distinguished by a line pattern (see fig. -).
To check the black earbud sizes
The black earbud sizes are distinguished by the inside color (see fig. -).
Black earbud sizes (inside color)
Small

S M
(Orange) (Green)
To detach an earbud (see fig. -)
While holding the headset, twist and pull the earbud off.
 Tip
If the earbud slips and cannot be detached, wrap it in a dry soft cloth.
To attach an earbud (see fig. -)
Push the parts inside of the earbud into the headset until the projecting part of the
headset is fully covered.
To clean the earbuds
Remove the earbuds from the headset, and wash them with a mild detergent solution.

Specifications

Cord: 1.2 m (47
4 lines
Gold-plated mini plug (for microphone plug) / Mass: Approx. 3 g (0.11 oz) (without
cord)
<Headphones>
Type: Closed, dynamic / Driver unit: 9 mm, dome type (CCAW) / Power handling
capacity: 100 mW (IEC*) / Impedance: 16 Ω at 1 kHz / Sensitivity: 100 dB/mW /
Frequency response: 8 – 22,000 Hz
<Microphone>
Design: In-line microphone / Type: Electret condenser / Open circuit voltage level:
–38 dB (0 dB = 1 V/Pa) / Effective frequency range: 20 – 20,000 Hz
<Supplied accessories>
Earbuds S (2), M (2), L (2) / Card warranty (1) / Operating Instructions (1)
* IEC = International Electrotechnical Commission
Design and specifications are subject to change without notice.
"WALKMAN" and "WALKMAN" logo are registered trademarks of Sony Corporation.
Precautions
 Please keep your headset clean at all times especially inside the rubber earbud. (see fig.
)
If any dust or ear wax is inside the earbud, you may experience some listening
difficulties.
 Listening with the headset at high volume may affect your hearing. For traffic safety,
do not use while driving or cycling.
 The earbuds may deteriorate due to long-term storage or use.
 Install the earbuds firmly onto the headset. If an earbud accidentally detaches and is
left in your ear, it may cause injury.
Note on static electricity
In particularly dry air conditions, mild tingling may be felt on your ears. This is a result
of static electricity accumulated in the body, and not a malfunction of the headset.
The effect can be minimized by wearing clothes made from natural materials.
Optional replacement earbuds can be ordered from your nearest Sony dealer.
Large

L
(Light blue)
/ in.) / Plug: Gold-plated stereo mini plug (for headphone plug),
1
4