Installation Procedure - Whirlpool LSA1300 User Manual

Installation procedure

Before you start:
• Parts removed during installation like screws, inlet
valve plug, etc. must be properly disposed.
• It is necessary to remove all shipping materials
for proper operation and to avoid excessive noise
from the washer.
Excessive Weight Hazard
use two or more people to move and install
washer.
Failure to do so can result in back or other injury.
1. Move Machine to the final location
move washer to within 1.5 m (59 inch) of
its final location; it must be in a fully upright
position.
Note:
To avoid floor damage, set washer onto cushion before
moving it and make sure lid is taped shut.
2. tilt the Machine
Tilt/ tip the machine sideways. Ensure to
place the machine over carton/foam support
on the floor to prevent the damage to floor or
product. It is recommended to use the inner
foam cushion for support before tilting the
machine.
Whirlpool | User Manual
3. ReMove the shipping bRacket
Remove the shipping bracket from bottom,
by removing two screws using a Phillips (star)
screw driver.
IMPORTANT Failing to do so can result in
excessive noise during spin/rinse operation.
4. set the Machine upRight
Set the machine upright and remove all
packing supports from inside of the basket.
5. attach dRain hose to dRain poRt
The drain hose connection
demonstrated by the service engineer when
he comes to install your washing machine.
However, the steps for the connections are
give below for your reference.
Steps to follow
insert the drain hose to the drain outlet
area of the machine.
A) Press the hose clamp.
B) While Pressing, push the clamp and the
hose simultaneously towards the body.
C) Release the hose clamp after insertion.
will be
7