Husqvarna Viking Designer Topaz 25 User Manual page 68

Note: If "Automatic Jump Stitch Trim" is activated in the SET Menu
the machine will cut the thread end automatically and the machine will
not stop. Hold the thread end when starting to embroider so that you can
easily remove it when cut.
you to change color. Re-thread with the next color and
segment is tied off at the end and the needle thread is cut.
Note: If "Automatic Jump Stitch Trim" is activated in the SET Menu,
the machine will also cut the thread after you have changed to a new
thread color. When you start embroidering again, hold the thread end so
you can easily remove it when cut.
Not all designs are programmed for Automatic Jump Stitch Trim. Jump
stitch trim commands can be added to any design using the downloadable
software. See page 24.
10. When the embroidery is completed your machine stops
automatically. The needle and bobbin thread are cut.
The needle and presser foot raise automatically for easy
66