Danby DPA140HEAUBDB Owner's Use And Care Manual page 9

Operating Instructions
REMOTE CONTROL INSTRUCTIONS
•
The air conditioner will not respond if curtains, doors or other materials block the signal from the
remote control to the unit.
•
Prevent any liquid from contact with the remote control. Do not expose the remote control to direct
sunlight or heat.
•
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner
may not function properly. Use curtains to prevent the sunlight from falling on the receiver.
•
If other electrical appliances react to the remote control, either move these appliances to another
location or consult your local dealer.
•
Do not mix old and new batteries or batteries of different types (if applicable).
•
Do not leave the batteries in the remote control if it is not going to be used for more than 2
months.
•
Dispose of the old batteries in special containers such as those found in sales outlets that sell
batteries.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
1. Reorient or relocate the receiving antenna
2. Increase the separation between the equipment and receiver
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
4. Consult the dealer or an experienced radio/TV technician for help
Changes or modifi cations not approved by the party responsible for FCC compliance could void the
user's authority to operate the equipment.
This appliance complies with Part 15 of the FCC Rules.
Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
This device complies with Canadian CAN ICES-3 (B) / NMB-3 (B)
CAUTION
6