Husqvarna K770 Workshop Manual page 63

6.15.2 To remove the bearings
1. Remove the bearings with a counter stay device or a
slide hammer and internal bearing extractors. See
Servicing tools overview on page 14 .
2. Use bearing extractor TMIC C10-12 for bearing 1,
TMIC C12-15 for bearing 2 and TMIC C17-20 for
bearing 3.
2
Note: Do not remove the bearings from the lid. They
are supplied with the lid as a kit.
701 - 002 -
1
3
6.15.3 To install bearings 1 & 2
To install the bearings, use a press and Husqvarna
Servicing tools overview on page
bearing press. Refer to
12 . Make sure that the blade guard is level.
1. Put a wooden block of applicable size below bearing
1 and 2 as support.
2. Use the small support from the tool kit to push the
bearings into position.
6.15.4 To install bearing 3
• To install the bearing you can use a standard press
in combination with a Husqvarna bearing press. See
Servicing tools overview on page 12 . You can also
use a Husqvarna bearing press without a standard
press.
6.15.4.1 To use Husqvarna bearing press
• Tighten the nut with a 13mm wrench.
Repair and servicing - 63