Connections; Figure 2. Rear Panel Rj-45 Jacks; Figure 3. Side Panel Terminal Block - ADTRAN Hub Installation And Maintenance Manual

10Base-T Hub Installation and Maintenance Practice

Connections

The 10Base-T Hub incorporates eight 10Base-T Ethernet ports (including one cross-over LAN
connector/daisy-chain port). Up to seven platforms, or other equipment, can be connected to
the hub using its 10Base-T Ethernet ports.
• All Ethernet equipment connections to the 10Base-T Hub are made using modular RJ-45
jacks (labeled 1 through 8) located on the rear panel (see
• Power connections are made to a terminal block located on the side panel of the 10Base-T
Hub (see Figure
• A cross-over switch allows the first port to connect directly to the LAN, or allows the daisy-
chaining of multiple hubs.
2
3).

Figure 2. Rear Panel RJ-45 Jacks

Figure 3. Side Panel Terminal Block

Figure 2).
61181012L1-5C