Machine Settings - Smeg BCC02 Manual

Use / Cleaning and maintenance

MACHINE SETTINGS

(Fig. C-G)
Through a programming menu it is possible
to set the water hardness and the acoustic
signals.
Activation / deactivation of acoustic
signals.
The acoustic signals can be disabled /
enabled by keeping the keys (17)
(20) pressed for three seconds; the key
(17) flashes three times indicating the
memorization of the setting.
Setting the water hardness.
To access the water hardness programming,
press the keys (16)
simultaneously for at least 3 seconds, the
LEDs (21) , (22)
up flashing.
• Choose the water hardness, referring to the
following table, pressing the key (16)
, the LED relating to the selected hardness
lights up steadily, the others go off.
Led Hardness
Light
21
Medium
22
Hard
23
• To memorize the selected hardness,
press keys (16)
simultaneously for at least 3 seconds or do
not press any key for 15 seconds.
EN - 12
and
CLEANING AND MAINTENANCE
(Fig. C-E-G-H-I-L)
Manual rinse
• Make sure that the Primary program is
and (20)
, (23) light
• With the machine ready to dispense and
• At the end of the washing cycle, the keys
Cleaning of the machine body
For a good preservation of the external
surfaces it is necessary to clean them regularly
at the end of each use, after letting them cool.
Clean with a soft cloth dampened with water.
and (20)
To prolong the machine operation
and preserve the aroma and taste of
the coffee, it is recommended to use
the Smeg Softener Filter (optional,
not supplied). For installation and
operation, follow the instructions
that accompany the accessory.
Once installed, set the water
hardness level to 'Light' following
the instructions in the previous
paragraph.
selected with keys (16), (17), (18), (19)
illuminated in white.
the drip tray mounted, press the keys (20)
and (19) simultaneously for at
least 3 seconds: the machine will rinse the
coffee circuit (coffee dispenser 11) and the
water circuit (steam wand 30).
light up steadily.
Never immerse the machine body
(1) in water or other liquids.
Allow the machine to cool down
before cleaning.