Kenwood TK-3217 Service Manual page 20

DISASSEMBLY FOR REPAIR /
■ Attaching the positive terminal to the chassis
Always attach the positive terminal to the chassis, using
the following procedures, before mounting the TX-RX unit onto
the chassis.
1. Remove the holder assembly
the positive terminal.
2. Mount the packing of the positive terminal into the chassis
c
hole .
3. Mount the holder assembly into the packing of the positive
v
terminal .
■ Mounting the chassis to the case assembly
1. Confirm that the waterproof packing attached to the
circumference of the chassis is securely inserted in the
z
groove of the chassis .
2. Attach the speaker to the speaker recess of the case
x
assembly . Make sure the speaker is securely inserted.
3. Insert the upper part of the chassis into the case assembly
Note: Take care that the speaker lead wire is not caught by
the microphone element.
v
4. Press the chassis and the case assembly together to
attach them.
x z
from the packing
2
1
4
1
Confirm that the
waterproof packing is
securely inserted in the
groove of the chassis.
维修拆卸
■ 把正极端子安装到机架
把TX-RX单元组装到机架之前， 必须按照以下的顺序把电池
正极端子安装到机架。
1. 从正极端子的垫片
of
2. 把正极端子的垫片安装到机架孔上。
3. 把支架安装到正极端子的垫片上。
3
■ 安装机壳机架
1. 确认机架四周的防水垫是否确实进入机壳的槽里。
2. 把扬声器安装到机壳的扬声器安装部
镶嵌好。
2
确认防水垫是否确实
地进入机架的槽里。
3. 把机架上部插到机壳里。
c
.
注∶请不要让扬声器引线勾住麦克风元件。
v
4. 按压机架 ，使机架和机壳成为一个整体。
TK-3217
z x
上取下机架 。
c
v
x
， 确保扬声器确实地
c
z
19