Preparing To Connect The Water; Attaching The Edge Protection; Side-By-Side Installation - Bosch B36IB Series Installation Instructions Manual

̈
Select screws according to the thickness of the wooden
beam: length = min. 2.5 x beam thickness, diameter
#12 or #14.
Specify the number of screws according to the
cavity width, thereby ensuring that the beam can be
attached securely.
According to the subsurface:
̈
Locate wall studs near the rear panel of the cavity and
mark drill holes in the beam
or
̈
Fasten suitable dowel into the rear wall.
̈
Predrill the wooden beam.
̈
Attach the wooden beam to the rear panel of the cavity.
8.

Preparing to connect the water

(only for appliances which require a water connection)
m
CAUTION
Turn off the main water tap to prevent damage caused
by leaking water.
̈
Attach the connecting pipe to the shut-off valve
according to the instructions supplied by the
manufacturer of the ice maker installation kit.
̈
Install the connecting pipe.
Always observe the indicated gap dimensions to
prevent damage to the connecting pipe when pushing
in the appliance.
̈
Attach the connecting pipe to the floor with adhesive
tape.
20
NOTE
m
9.

Attaching the edge protection

To protect the corners of the installation cavity, attach the
supplied protective brackets with adhesive tape.

10. Side-by-Side installation

If a side-by-side installation is intended, now connect the
two appliances together.
Detailed information on installation can be found in
the separate installation instructions for the sealing kit
for side-by-side installation.
The following work steps must be performed on two
interconnected appliances.