Bosch SPV68B53UC User Manual page 45

Issue
Water is left in the
appliance at the end
of the program.
Appliance cannot be
switched on or oper-
ated.
Appliance does not
start.
Wash cycle starts
up automatically.
Appliance stops dur-
ing the cycle or cuts
out.
Appliance door can-
not be closed.
Cause and troubleshooting
Filter system or area under the filters is blocked.
Clean the Filters → Page 35 .
1.
Clean the Wastewater pump → Page 46 .
2.
Program has not yet ended.
Wait until the program ends or terminate the
▶
program with Reset.
→ "Terminating the wash cycle", Page 28
▶
Software update is taking place.
Wait until the software update has finished.
▶
Appliance functions have failed.
Pull out the power cord plug or switch off the
1.
breaker.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
The breaker has tripped.
Check the relevant breaker.
▶
Power cord is not inserted.
Check whether the power outlet is working.
1.
Check whether the power cord plug is properly
2.
inserted in the power outlet and on the rear of
the appliance.
Appliance door is not closed properly.
Close the appliance door.
▶
You did not wait until the cycle ended.
→ "Terminating the wash cycle", Page 28
▶
Appliance door is not closed properly.
Close the appliance door.
▶
Power and/or water supply has been interrupted.
Check the power supply.
1.
Check the water supply.
2.
Upper rack is pressing against inner door and
preventing appliance door from being closed se-
curely.
Check whether the rear panel of the appliance
▶
is being pressed in by a power outlet or a hose
holder that has not been removed.
Arrange the dishware so that no parts project
▶
beyond the rack and prevent the appliance
door from closing properly.
Door lock has been activated.
Close the appliance door with greater force.
▶
Troubleshooting en-us
45