Table of Contents
Advertisement
3. INSTALLATION
3-1. Installing the operation panel
❶
❶
❷
❷
❶❷
❶❷
❶❷
❶❷
– 3 –
1) The figure given on the left shows the operation
panel in the delivered state.
2) Remove fixation screws ❶ (two pieces). Also take
out screws ❷ (two pieces) from the plastic bag.
3) Adjust the position of the operation panel as
shown in the figure given on the left. Secure the
operation panel on the table by tightening four
screws ( ❶ and ❷ ) you have removed in the
aforementioned step of procedure.
4) Adjust the inclination angle of the operation panel
as you like for ease of use.
(When you operate the sewing machine standing,
the recommended difference in angle between
the operation panel and the table is 60° to 70°.
When you operate the sewing machine sitting, the
recommended difference in angle between them
is 80° to 90°.)
Advertisement
Table of Contents
