Troubleshooting And Repair - Viper 25537 Owner's Manual

STEPS FOR LONG-TERM STORAGE
1. Mix an appropriate amount of fuel stabilizer, such as
STA-BIL®, to fresh gasoline, in the ratio recommended on
the stabilizer packaging. Run the engine for five minutes
to distribute the stabilizer mixture throughout the fuel
system. This will prevent gum, varnish and corrosion build
up in your fuel system during long-term storage for up to
12 months.
NOTE: It is recommended that fuel tank is drained and new
fuel stabilizer is added every four months. Starting engine
once a month to help preserve engine is also recommended.
2. Run engine for 10-15 minutes to ensure that the stabilizer
reaches the carburetor.
a. ) Move fuel lever to the OFF position and start engine.
Run until engine runs itself out of any residual fuel left in
fuel cup and fuel lines. (It is normal for the engine to run
two to three minutes before the fuel is completely out of
system.)
3. Store engine in its upright position.
4. Remove all debris from engine.

TROUBLESHOOTING AND REPAIR

At Ardisam we build quality and durability into the design
of our products; but no amount of careful design by us, and
careful maintenance by you, can guarantee a repair-free life for
your Viper® Engine. Most repairs will be minor, and easily fixed
by following the suggestions in the troubleshooting guide in
this section.
This section will help you pinpoint the causes of common
problems and identify remedies. For more complicated repairs
please contact one of our authorized service centers (find
these on our website at www.getearthquake.com/Locations/
ServiceCenter) or contact Ardisam Customer Service. Ardisam
will make the necessary repairs or resolution if a service center
is not available. We will always be glad to answer any questions
you have, or help you find suitable assistance. To order parts or
inquire about warranty, please visit "contact us" on our website
www.getearthquake.com.
Get parts online at www.GetEarthquake.com or Call 800-345-6007 M-F 8-5 CST
WARNING
FUEL IS HIGHLY FLAMMABLE AND MUST BE HANDLED
WITH CARE. NEVER FILL OR DRAIN THE FUEL TANK
WHEN THE ENGINE IS HOT OR RUNNING. ALWAYS MOVE
OUTDOORS TO FILL OR DRAIN FUEL FROM THE TANK.
DO NOT REMOVE FUEL WHILE SMOKING, NEAR OPEN
FLAME, OR OTHER POTENTIAL HAZARDS.
FUEL IS TOXIC. DO NOT SIPHON FUEL BY MOUTH.
DO NOT STORE ENGINE INSIDE A BUILDING WITH FUEL IN
THE TANK. POTENTIAL SPARKS MAY BE PRESENT CAUSING
IGNITION OF FUEL AND FUEL VAPORS.
FAILURE TO FOLLOW SAFETY INSTRUCTIONS CAN CAUSE
SERIOUS INJURY OR DEATH.
DO NOT REMOVE FUEL WHILE SMOKING, NEAR OPEN
FLAME, OR OTHER POTENTIAL HAZARDS.
CHECK ENGINE REGULARLY FOR LOOSE NUTS AND BOLTS.
KEEP THESE ITEMS TIGHTENED.
ORDERING REPLACEMENT PARTS
Parts can be obtained directly from the factory. To order
parts visit www.getearthquake.com or call 1-800-345-6007.
Please include the following information with your order: part
numbers; part description; quantity; and model number and
serial number.
SPARE PARTS
Only use approved Viper® spares.
Owner's Manual
301CC VIPER 4-CYCLE ENGINE
15