Operation - Husqvarna LT 5005 Operator's Manual

Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Do the daily maintenance. Refer to
schedule on page 10 .
• Make sure that the locking knob for the cover is fully
tightened and not damaged.
To start the product
1. Set the throttle control in the start position.
957 - 002 - 14.10.2019

Operation

2. If the engine is cold, push the primer bulb 5 times.
Maintenance
3. Set the choke control in the correct position.
4. Pull the starter rope handle slowly until you feel
5. Release the starter rope handle to let the starter
6. Pull the starter rope handle until the engine starts.
7. Open the choke control gradually until it is fully open.
8. Let the engine operate at idle speed for 2–3 minutes
a) If the engine is cold, close the choke.
b) If the engine is warm or the ambient temperature
is high, open the choke.
resistance.
rope go back.
before you apply full throttle.
9