Husqvarna 131R Workshop Manual page 25

5. Disconnect the throttle wire from the carburetor.
6. Disconnect the cables.
7. Remove the 2 screws (A) and the 4 screws (B) and
pull away the clutch drum assembly (C). Remove
the 2 washers.
A
675 - 002 - 23.04.2018
B
C
8. Remove the 2 screws (D), the cables (E), the
ignition module (F) and the 2 washers (G).
G
F
9. Remove the 2 screws (H) and the spacers that hold
the centrifugal clutch. Lift off the clutch. Remove the
2 spacers between the flywheel and the centrifugal
clutch.
10. Attach the puller on the flywheel. Hold the puller to
loosen and remove the nut.
E
D
H
H
Repair instructions - 25