Quoizel BDS8408AGV Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (1) A19 Medium Base Bulb 100W Maximum, Medium Base Vintage Bulbs is recommended, bulb not included.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.
Fixture can only be mounted in the direction indicated on page 2.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Crossbar
A Assembly
x 1
Alternate
B Mounting screw
x 2
Lock screw
C
x 2
-
STEP 1 Install Glass Panel
A. Insert the Glass Panel (F) into the slot in the bottom edge of the
Cage (E) and press the tabs on the top edge of the Cage (E) onto
the top edge of the Glass Panel (F) to secure it.
Tab
Slot
2018 QuoizelInc.
for product cleaning tips. Go to the
20-30 minutes
Fixture Body
D
x 1
E
Glass Panel
F
x 4
F
E
Figure 1
visit us on-line at www.quoizel.com
Installation Guide #IS-BDS8408AGV
For Style BDS8408AGV
Care + Maintenance selection.
-
STEP 2 Install Cage
A. Align the tabs in the top edge of the Cage ( ) to the tabs in the
fixture hood on the Fixture Body (D). Secure by threading Lock
Screws (C) onto the tabs and hand tighten until snug with
screwdrivers.
Cage
x 1
Fixture Hood
Figure 2
-
STEP 3 Installing the Crossbar Assembly
A. Pass the supply wires through the Crossbar Assembly (A). Attach
the Crossbar Assembly (A) to the Outlet Box with the head of the
Green Ground Screw facing you. Secure the Crossbar Assembly (A)
with Outlet Box Screws (not included). Tighten until snug
Note: Use the Alternate Shorter Mounting Screw (B) if your
installation requires a shorter mounting screw.
Outlet Box
Mounting Screw
or Alternate Short
Mounting Screw
1of3
E
Tab
D
C
E
.
Supply Wires
with Ground Wire
A
Outlet Box Screws
(not included)
Figure 3
ReleasedDate:2018-09-12