Steps
1. Align the screw holes on the hard drive assembly with the mounting points on the palmrest.
2. Replace the four M3x3 screws to secure the hard drive in place and connect the hard drive cable to the connector on the system
board.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
Touchpad
Removing the touchpad button board
Prerequisites
1. Follow the procedure in
2. Remove the
SD
Card.
3. Remove the
base
cover.
4. Disconnect the battery.
38
Disassembly and reassembly
After working inside your
computer.
before working inside your
computer.