Configuring Hard Drive Warnings; Configuring Network Warnings - Lorex N861 Series User Manual

Table of Contents

Using the Main Menu

16.4.9 Configuring Hard Drive Warnings

Hard drive warnings will notify you if an issue is detected with the hard drive.

To configure hard drive warnings:

1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.

2. Click

, then click EVENT. Click the WARNING tab on the side panel, then click

the HDD tab on the top panel.

3. Under Event Type, select the hard drive event you would like to configure. Check Enable to

activate the selected warning.

• No HDD: No hard drive detected.

• Disk Error: A hard drive error has been detected.

• Disk Full: The hard drive is full or almost full. You can enter the percentage of disk space

remaining that will trigger a warning under Less Than (e.g. when less than 10% of the hard

drive is empty, trigger a warning). Disk Full warnings will not occur if overwrite is enabled.

• All: Configure warnings for all hard drive events.

4. Configure the responses the system will take when the selected event occurs:

• Alarm Out: Check the box to activate alarm output devices (not included) when the se-

lected event occurs. Select the alarm output devices that will be activated, then enter the

number of seconds the alarm output device(s) will activate after the selected event occurs

next to Latch.

• Show Message: Show a popup message on the monitor.

• Send Email: Check to enable email alerts. You must configure email alerts before you will

be able to receive them (see 16.4.4 Configuring Email Alerts, page 78).

• Buzzer: Check to activate the system buzzer.

5. Click Apply to save changes.

Network warnings will notify you if there your system loses connection to the Internet or local

network or if there is an issue on your network.

#LX400113; r. 2.0/56306/56316; en-US

Table of Contents

N861d63b