Do not dispose of the battery in fire. 17. Use only genuine HITACHI replacement parts. If the battery is burnt, it may explode. 18. Do not use power tools for applications other than When drilling in wall, floor or ceiling, check for those specified in the Handling Instructions.
SPECIFICATIONS POWER TOOL Model DS9DVF3 DS12DVF3 No-load speed (Low/High) 0 – 280 / 0 – 840 / min 0 – 350 / 0 – 1050 / min Wood 21 mm 25 mm (Thickness 18mm) Drilling Metal Steel: 10 mm, Steel: 12 mm, (Thickness 1.6mm) Aluminum: 12 mm Aluminum: 15 mm...
120 minutes have elapsed after starting of the 2. Tightening torque adjustment charging, stop the charging and contact your (1) Tightening torque HITACHI AUTHORIZED SERVICE CENTER. Tightening torque should correspond in its intensity CAUTION to the screw diameter. When too strong torque is If the battery is heated due to direct sunlight, used, the screw head may be broken or be injured.
Page 14
When the shift knob is set to “LOW”, the drill it may happen that the clutch does not engaged rotates at a low speed. When set to “HIGH”, the and that the motor is locked. In such a case, please drill rotates at a high speed.
(B) (Fig. 10). Repair, modification and inspection of Hitachi Power (b) The angle can be adjusted in 5 steps (0°, 20°, Tools must be carried out by a Hitachi Authorized 40°, 60°, 80°). Service Center. Adjust the angle of the hook to the desired This Parts List will be helpful if presented with the position for use.
Page 18
Hitachi Koki Co., Ltd. Code No. C99135921 Printed in China...