Advertisement
Using a 3-Door Programmable Garage Door Receiver to control
other electronic devices in the home
With the help of an electrician, you can use your 3-Door Programmable Receiver
to control a number of low-voltage electronic devices in your home, such as
low-power "Malibu-type" exterior lighting systems, home security systems,
certain spa heaters, and other non-AC, switch-controlled items. To control these
devices, the 3-Door Programmable Receiver's outputs can be set to provide a
latched ground signal instead of a pulse.
How to switch the receiver output(s) from pulsed to latched
1. Repeatedly tap the button on the face of the Programmable Receiver until the
LED illuminates next to the output number that you wish to be with a latched
output.
2. Press and hold for at least 5 seconds the button on the Clifford remote
control. The LED will blink twice, then turn off to indicate that output will
provide a latched ground signal.
3. Repeat steps 1 and 2 for any other outputs that will have a latched output.
How to switch an output from latched to pulsed:
1. Repeatedly tap the button on the face of the Programmable Receiver until the
LED illuminates next to the output you wish to use.
2. Press the button on the Clifford remote control. Release it as soon as the LED
turns off.
Remote controls and remote control batteries are available from
your local Authorized Clifford Dealer or you may call the Clifford
Customer Service Department toll-free at (8OO) 824-32O8.
© Copyright Clifford Electronics, Inc., 1995
31-014B/ACGOM/495
Advertisement
