Electrolux IK2685TR User Manual page 60

60 www.electrolux.com
Problem
The compressor operates
continually.
Water flows inside the re‐
frigerator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
Possible cause
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.
7.2 Replacing the lamp
Solution
Refer to "Operation".
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance.
The appliance is equipped
with a long-life LED interior
light.