Getting Started - Remington PowerSeries Aqua PR1340 Quick Start Manual

PARTS
1. On/off switch
2. Pivoting head and cutter assembly
3. Flexing heads
4. Hairpocket
5. Charging indicator light
6. Detail trimmer

GETTING STARTED

CHARGING YOUR SHAVER
• Ensure the appliance is turned off.
• Connect the shaver to the adaptor and then to the mains.
• Charge for at least 24 hours when using for the first time.
• Allow 4 hours for a full charge.
• When charging, the green indicator light will show solid. When fully charged, the
green indicator light will turn off.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
• The shaver automatically adjusts to a mains voltage between 100V and 240V.
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to four weeks to allow time
for your beard and skin to become accustomed to the new shaving system.
SHAVING
Note: This shaver is for cordless use only.
1. Make sure your shaver is properly charged.
2. Switch the shaver on.
3. Stretch the skin with your free hand so the hairs stand upright.
4. Only apply light pressure on the shaving head while shaving (pressing too hard can
damage the heads and make them vulnerable to breakage).
5. Use short, circular strokes.
SHAVING WITH SHAVING GEL
Follow the same instructions as dry shaving if using shaving gel.
Caution: After use with shaving gel, please rinse the head and cutters under warm water
to clean away any excess gel and debris.
7. Trimmer release button
8. Power port
9. Adaptor (not shown)
10. Cleaning brush (not shown)
11. Head guard (not shown)
5