Table of Contents
Advertisement
4.3.10 LCD Panel
1. Remove the rear cover, as described earlier.
2. Refer to fig. "LCD panel" below.
3. Unplug the connectors on the Main Supply Panel [a] and
the LED & IR board [c].
4. Unplug the outer connectors [d] from the mid-range
loudspeakers.
5. Do NOT forget to unplug the LVDS connector [e] from the
SSB. Important: Be careful, as this is a very fragile
connector!
f (1x)
g (2x)
g (2x)
f (3x)
Figure 4-22 LCD panel [2/2]
Mechanical Instructions
a
f (2x)
d
Figure 4-21 LCD panel [1/2]
7
G_16850_015.eps
110107
LC7.1L LA
6. Remove T10 parker screw [b] that holds the Side I/O
module bracket.
7. Remove T10 parker screws [f] of the central sub-frame.
8. Remove LCD panel fixation screws [g] and lift the complete
central sub-frame from the set (including the PSU, SSB,
and Side I/O boards and wiring).
9. Lift the LCD panel [7] from the front cabinet.
e
4.4
Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
•
While re-assembling, make sure that all cables are placed
and connected in their original position. See figure "Cable
dressing".
•
Pay special attention not to damage the EMC foams.
Ensure that EMC foams are mounted correctly (one is
located above the LVDS connector on the display, between
the LCD display and the metal sub-frame).
4.
EN 15
b
d
c (1x)
G_16860_067.eps
310107
Advertisement
Table of Contents
