Making Connections; Connecting To Power; Dc Power (Power Outlet) - ViewSonic M2 User Manual

Making Connections

This section guides you on how to connect the projector with other equipment.

Connecting to Power

DC Power (Power Outlet)

1. Connect the power cord to the power adapter.
2. Connect the power adapter to the DC IN jack at the rear of the projector.
3. Connect the power cord plug to a power outlet. When connected, the status LED
will turn red.
NOTE: When installing the projector, incorporate a readily accessible disconnect
device in the fixed wiring, or connect the power plug to an easily
accessible outlet near the unit. If a fault should occur during operation of
the projector, use the disconnect device to switch off the power supply,
or disconnect the power plug.
3
1
18
2