Table of Contents
Advertisement
MB-280-02
REMOVABLE BATTERIES
Removable batteries can consist of a single large industrial battery or a pack of smaller batteries
assembled on a removable tray.
The removable battery may be one of a few different types. One that slides or rolls out of the side
of the vehicle (ROBB) or lifted out of the vehicle from above (LOBB).
WARNING
• Use the proper equipment when handling and transporting removable batteries.
Equipment that is used to lift and support removable batteries should be rated
at a minimum of 1.5 times the total battery weight.
• Keep all body parts out from underneath any battery that is not installed and
latched in the vehicle.
Failure to follow these rules may result severe bodily injury and/or property damage.
WARNING
Before removing a battery pack or industrial battery:
1) Park the vehicle on a level surface. If removing a ROBB, the vehicle should be
positioned as close as possible to the platform where the battery will be stored.
2) Place the Direction Control switch in the center OFF position.
3) Make sure the Start switch is in the OFF position.
4) Set the park brake.
Roll Out Battery Box (ROBB) with battery Dolly
Remove
5. Disconnect the battery cable from the ROBB.
6. Position the ROBB dolly as close as possible to
the vehicle, aligned with the battery box.
7. Using the ROBB handle, twist to unlock the box
from the frame and pull the box out 6 inches.
8. Pump foot pedal 1 to raise the dolly tray until it is
in contact with the bottom the ROBB.
9. While pushing the dolly up against the vehicle, pull
the ROBB out of the vehicle and onto the dolly tray.
10. Tie the ROBB to the tray so that it cannot roll off.
11. SLOWLY depress foot pedal 2 until the tray starts
to lower and allow to lower all of the way down.
Install
1. Confirm the start switch is OFF and the parking brake is set.
2. The ROBB should be tied to the dolly tray so that it can not roll off.
3. Position the ROBB dolly as close as possible to the vehicle, aligned with the battery box.
4. Pump foot pedal 1 to raise the dolly tray until it is slightly above its location in the vehicle.
5. Untie the ROBB from the dolly and push forward until it starts to enter the vehicle.
6. Using the foot pedal 1 and/or foot pedal 2, adjust the vertical position of the dolly tray until
the ROBB can be easily pushed into the vehicle.
7. Lock the ROBB in place.
8. Connect the battery cable.
Operator Manual
Page 47
Advertisement
Table of Contents
