Samsung 713N Service Manual page 14

5 Troubleshooting
Notes: 1. Before troubleshooting, setup the PC's display as below.
• Resolution: 1280 x 1024
• H-frequency: 64 kHz
• V-frequency: 60 Hz
2. If no picture appears, make sure the power cord is correctly connected.
3. Check the following circuits.
• No raster appears: Function PBA, Main PBA, I/P PBA
• 5V develop but no screen: Main PBA
• 5V does not develop: I/P PBA
4. If you push and hold the "
automatically returns to the factory preset.
5-1-2 No Power
When Pin 4 of CN600 is 0V
does proper DC 13V, 5V
appear at Pin 1, 2 and 6, 7 of
CN600 separately?
Yes
When Pin 4 of IC600 is DC
0.5V
does proper DC 0.5V
Yes
When Pin 2, 3 of IC601 is
DC 3.3V does proper DC
4.3V appear at Pin 1 of
Yes
When Pin 2, 3 of IC601 is
DC 4.3V does proper DC
2.5V appear at Pin 4 of
* 0V means power on state.
When the monitor work well except DPMS and power switch off,
0V should be applied to number 4 of CN600.
5-2
(Enter/Source)" button for more than 5 seconds, the monitor
Check Function Ass'y.
Yes
No
Change IP Board.
No
Check IC600 and related
No
Check IC601 and related
No
Check IC601 and related
circuit.
circuit.
circuit.