Functional Description - Makita JR3000V Instruction Manual

FUNCTIONAL
DESCRIPTION
2
1. Bolt
2. Shoe
3
1. Lock button/Lock-off button
2. Switch trigger
3. Speed control screw
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Adjusting the shoe
002485
When the blade loses its cutting efficiency in one place along its cutting edge,
reposition the shoe to utilize a sharp, unused portion of its cutting edge. This
1
will help to lengthen the life of the blade.
To reposition the shoe, loosen the two bolts holding the shoe and slide the
shoe forward or back to the desired position. Then tighten the two bolts to
firmly secure the shoe.
Switch action
002492
CAUTION:
1
• Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
2
For tools with the lock button
To start the tool, simply pull the switch trigger. Tool speed is increased by
increasing pressure on the switch trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then push in the lock but-
ton.
To stop the tool from the locked position, pull the switch trigger fully, then
release it.
A speed control screw is provided so that maximum tool speed can be limited
(variable). Turn the speed control screw clockwise for higher speed, and coun-
terclockwise for lower speed.
For tools with the lock-off button
To prevent the switch trigger from accidentally pulled, a lock-off button is pro-
vided.
To start the tool, press in the lock-off button and pull the switch trigger.
Tool speed is increased by increasing pressure on the switch trigger. Release
the switch trigger to stop.
A speed control screw is provided so that maximum tool speed can be limited
(variable). Turn the speed control screw clockwise for higher speed, and coun-
terclockwise for lower speed.
5