Firewall Settings - Fujitsu DX100 S3 Setup Manual

Establishing a Connection between the ETERNUS DX and the Operation Management LAN
5
Remove the LAN cable between the RMT port on Controller 0 and the PC terminal.
Connect the LAN cables of the MNT ports on Controller 0 and Controller 1 to the network of the customer.
Then start the web browser from the PC terminal that is connected to the network and log in to ETERNUS Web GUI
again with the IP address that is set in the Setup Network Environment settings. After login, the Overview screen
appears.

Firewall Settings

6
Set the firewall for each service.
1.
Click the [System] tab, click [Network] in [Category],
and then click [Setup Firewall] in [Action].
2.
Enable or disable each service.
If the network environment for the MNT
IMPORTANT
port is not set up, some functions will be
unusable. Make sure to set up the network
environment.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Setup Guide
10
Copyright 2017 FUJITSU LIMITED
P3AM-7852-06ENZ0