Table of Contents
Advertisement
Troubleshooting
Troubleshooting
Should an error occur, first check the following points. If the distortion is still not eliminated,
the monitor should, if possible, be checked on another computer.
If you cannot solve the problem, please contact our Service Desk.
Having this problem?
No screen display
Power indicator is lit
Message: No Signal
Message: Frequency out of range:
## kHz / ## Hz
Please change the display mode
to 1920 x 1200 with 60 Hz
42
Check the following points:
► Check whether the computer is switched on.
► Check whether the data cable for the
monitor is correctly screwed into the monitor
port on the computer.
► Press any key on the computer keyboard.
The computer may be in power saving
mode.
► Alter the brightness and/or contrast until you
get a picture.
► Check whether the data cable for the
monitor is correctly screwed into the monitor
port on the computer.
► Check whether the computer is switched on.
The input signal (horizontal frequency and
refresh rate) at the displayed input does not
correspond to the technical data for the monitor.
► Reboot the system after connecting to the
monitor. The VGA interface does not support
"Hot Plugging".
► Adjust the video frequency range using the
computer software (see documentation for
the computer or display adapter).
► Set a different screen resolution using the
computer software (see documentation for
the computer or display adapter).
Fujitsu
Advertisement
Table of Contents
