Curtis iP1002 Owner's Manual page 8

Operations
How to using radio
1. Plug the AC Power cord into a power outlet and press the POWER button.
2. If necessary, press the RADIO/AUX button to radio mode.
3. Press the BAND button to switch between AM / FM radio station.
4. Automatic Tuning - Press and hold the TUNING UP or DN buttons until the
display begins to move, then release the buttons. The tuner will scan up or down
the band until it finds the first strong station, and then stop on that station. Repeat
this process until the tuner stops on your desired station.
5. Manual Tuning - Press and release the TUNING UP or DN buttons repeatedly
until the display is showing the frequency of your desired station. Use the manual
tuning method to tune to weaker stations that are bypassed during Automatic
Tuning.
Antennas AM - If reception is weak, turn the unit to improve reception. FM - If
reception is weak, adjust FM Rod Antenna length and the angle to improve
reception.
Programming radio station presets
You can program as many as 10 FM and 10 AM radio station presets.
1. During power on mode, press RADIO/AUX button to select AM/FM band.
2. Press the TUNING UP/DN buttons to desire station you want store.
3. Press and hold the MEM/CLK SET button to activate the programming mode.
4. Press the TUNING UP/DN buttons to select the preset number you want to
store.
5. Press and hold the MEM/CLK SET button to store the station.
6. Repeat Steps 2 through 5 to program additional presets.
8