TP-Link TL-WR902AC User Manual page 38

Chapter 4
address). It is strongly recommended that you change your network name (SSID). This
value is case-sensitive. For example, TEST is NOT the same as test.
• Mode - Select the desired mode. It is strongly recommended that you keep the
default setting 11bgn
the router.
Note: If 11bg mixed mode is selected, the
be changed.
• Channel Width - Select any channel width from the drop-down list. The default setting
is Auto, which can automatically adjust the channel width for your clients.
• Channel - This field determines which operating frequency will be used. The default
channel is set to Auto. It is not necessary to change the wireless channel unless you
notice interference problems with another nearby access point.
• Enable Wireless Router Radio
disabled to allow or deny wireless access. If enabled, the wireless clients will be able
to access the router.
• Enable SSID Broadcast
name (SSID).
• Enable WDS Bridging
the router can bridge two or more WLANs.
Note: If this checkbox is selected, you had better make sure the following settings are correct.
• SSID (to be bridged)
You can also use the survey function to select the SSID to join.
• BSSID (to be bridged)
client. You can also use the survey function to select the BSSID to join.
• Survey - Click this button, you can search the AP which runs currently.
• WDS Mode - This field determines which WDS Mode will be used. It is not necessary
to change the WDS mode unless you notice network communication problems with
root AP. If you select Auto, then the router will choose the appropriate WDS mode
automatically.
• Key type - This option should be chosen according to the AP's security configuration.
It is recommended that the security type is the same as your AP's security type.
mixed, so that all 802.11b/g/n wireless devices can connect to
Channel Width
- The wireless radio of the router can be enabled or
- If enabled, the router will broadcast the wireless network
- You can select this to enable WDS Bridging, with this function,
- The SSID of the AP your router is going to connect to as a client.
- The BSSID of the AP your router is going to connect to as a
field will turn grey and the value will become 20M, and cannot
31