Initial Camera Setup - Vivitar DVR 880HD User Manual

Initial Camera Setup

1) Installing the Battery
Press / slide down the battery cover and insert the included lithium battery. Align with correct
polarity (+,-) of battery terminals. Close the battery cover.
Make sure the battery has been inserted properly into your digital camera, according to the
polarity shown inside the battery compartment.
Note:

Remove the battery from the camera when not in use for an extended period.

Some camera features (Flash) will not work if the battery power level is low.

When the battery power is low the battery icon turns red and the camera will automatically
turn off a few seconds later.

The energy status of the power is displayed on LCD as shown below:
Full battery power
Charging the Battery
To Charge the Battery:
1. Power off the camcorder.
2. Connect the camcorder using the USB built-in connector/USB cable to the computer‟s USB
port or to the AC Adapter (which is then connected to a standard wall socket).
3. Allow the battery to charge for at least 3 hours before using the first time.
4. The charge light will turn off when the battery is fully charged.
NOTE: While the device is recharging it cannot be used to capture images.
Medium battery power
6
Low battery power