Curtis iMODE iP9012 Owner's Manual page 16

Quick Starting Guide
To Playback iPod
1. Lift the Dock Release button. Locate the correct holder to use as shown on page 9.
2. Insert the holder onto the dock and slip the side tabs into place.Insert the iPod
onto the holder.
3. Gently push down so the connector on the iPod slides onto the connector on the
unit.
4. Press the edge area of the holder down gently (as shown) until it clicks into
place.
5. Once you connect the iPod, it will start charging the battery until it is full. (The
iPod can charge only when the unit is connected with the AC adapter.)
6. With an iPod connected, turn the unit on by slide the Power button to "ON"
position.
7. Operate the iPod as per its ownerʼs manual.
For music selections, the sound will be heard through the unit speakers.
For photo selections, the image will be seen on the unit screen.
For A/V selections, the sound will be heard through the unit speakers and the image
will be seen on the TFT screen.
Make sure to go into the Settings menu of your iPod and set the TV Out setting to
ON and set the TV Signal to NTSC; otherwise, you may not be able to view the
videos/ photos on your external TV.
• The photo and video selections are for iPod with video (5th generation). The photo
selection is also suitable for iPod photo.
When done, slide the Power button to OFF and also turn off the iPod.
16