Setting The Hydraulic Pump Neutral Position - Toro 74413 Operator's Manual

3. Tilt the seat forward.
4. Begin with either the left or right motion control lever.
5. Move lever to the neutral position but not locked
(Fig. 43).
3
Figure 43
1. Neutral locked position
2. Control lever
6. Pull the lever back until the clevis pin (on the arm
below the pivot shaft) contacts the end of the slot (just
beginning to put pressure on the spring) (Fig. 44).
2
6
9
1
m–4118
Figure 44
1. Clevis pin in slot
2. Nut
3. Nut—Left hand thread
4. Adjustment bolt
5. Pump rod
2
1
m–6282
3. Neutral potion
8
1
4 3
9
2
7
8
6. Double nuts
7. Jam nut
8. Yoke
9. Ball joint
7. Check where the control lever is relative to the notch in
the console (Fig. 43). It should be centered, allowing
the lever to pivot outward to the neutral lock position.
8. If adjustment is needed, loosen the nut and jam nut
against the yoke (Fig. 44).
9. Apply slight rearward pressure on the motion control
lever, and turn the head of the adjustment bolt in the
appropriate direction until the control lever is centered
in the neutral lock position (Fig. 43).
Note: Keeping rearward pressure on the lever will keep
the pin at the end of the slot and allow the adjustment
bolt to move the lever to the appropriate position.
10. Tighten the nut and jam nut (Fig. 44).
11. Repeat on the opposite side of machine.
Setting the Hydraulic Pump
Neutral Position
Note: Adjust the handle neutral first. That has to be correct
before you can perform the following adjustment.
Danger
Mechanical or hydraulic jacks may fail to support
the machine and cause a serious injury.
Use jack stands when supporting the machine.
Do not use hydraulic jacks.
Warning
The engine must be running so that you can adjust
the motion control. Contact with moving parts or
hot surfaces may cause personal injury.
Keep your hands, feet, face, clothing and other
body parts away from rotating parts, muffler, and
other hot surfaces.
You must make this adjustment with the drive wheels
turning.
1. Raise the frame and block up the machine so that the
drive wheels can rotate freely.
2. Disconnect the electrical connector from the seat safety
switch. Temporarily install a jumper wire across
terminals in the wiring harness connector.
3. Slide the seat forward, disconnect the prop rod and tilt
the seat fully forward.
36