Table of Contents
Advertisement
VIVOTEK
Hardware Installation - FE9382-EHV
Opening Dome Cover
First, use the supplied screwdriver to loosen the four screws and detach the dome cover from the
camera base. Then, follow the steps below to install the camera to either a ceiling or a wall.
Remove the stoppers and route cables through
the openings.
Rubber Stopper on the hole
for Power & IO Cables
Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, press the reset button longer to restore the factory settings and install again.
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the
Network Camera to reboot.
Restore: Press and hold the recessed reset button for at least several seconds to restore. Note
that all settings will be restored to factory defaults.
Micro SD/SDHC/SDXC Card Capacity
This network camera is compliant with Micro SD/SDHC/SDXC 32GB, 64GB, and other
preceding standard SD cards preferrably with class 6 speed.
14 - User's Manual
Tamper-proof Screw
Rubber Seal Plug on the
hole for RJ45 Ethernet
Cable
Advertisement
Table of Contents
