Samsung QND-6010R User Manual page 55

alarm input
You can set the alarm input type, activation time, and operation mode.
1. From the Setup menu, select the <event (
2. Click <alarm input>.
3. Set whether or not to <enable>.
4. Select the type.
• Normal open : It is normally open, but if it is closed, an
alarm will be triggered.
• Normal close : It is normally closed, but if it is open, an
alarm will be triggered.
5. Specify the <activation time>.
• Always : Always check if an alarm occurs. It activates in
operated mode when the alarm occurs.
If set to <Always>, the activation time cannot be changed.
`
• Only scheduled time : Check if an alarm occurs at a specified day of the week for a specified time
period. It activates in operated mode when the alarm occurs.
• [Clear (
)] : Reset all settings.
• Minute : Click an area in Activation Time and set the time
by minutes.
• Hour : Drag your mouse at Activation Time and set the
time by hours.
6. Specify an operation that will perform if an alarm occurs.
• FTP : Specify the use of FTP transfer in the alarm input
setup.
Refer to "FTP / E-mail" for more details. (page 51)
`
• E-mail : Specify the use of email transfer in the alarm input
setup.
Refer to "FTP / E-mail" for more details. (page 51)
`
• Record : You can set up the alarm to record to a Micro SD
card or an NAS when operating.
Set <Device> to <On> in <Storage>. (page 52)
`
• Alarm output1 : Select whether to set the alarm output if an alarm is incoming, and specify the alarm
output time.
7. When done, click [apply ( )].
)> tab.
time schedule
You can configure settings to transmit images at regular intervals at a scheduled operation time regardless of
the occurrence of an event.
1. From the Setup menu, select the <event (
2. Click <time schedule>.
3. Set whether or not to <enable>.
4. Specify the <transfer interval>.
5. Specify the <activation time>.
• Always : Always activates in operated mode at the set
interval.
• Only scheduled time : Periodically activates in operated
mode at a specified time and date.
The transfer interval setting value must be smaller than the preset
`
J
activation interval to succeed in image transmission.
6. Specify the activation conditions.
• FTP : Specify the use of the FTP transfer if an event occurs.
Refer to "FTP / E-mail" for more details. (page 51)
`
7. When done, click [apply ( )].
)> tab.
English _55