Philips PET740 Service Manual page 3

1.0 TECHNICAL SPECIFICATION
Factory Service Mode (FSM)
Procedure to check the software version of
your portable DVD Player
1. Press [SETUP] to enter the setup Meun
2. Press [RETURN] and then press "1" -> "2" -> "3"
by remote control
3. The display will show the software version as the
date of which the software was built on the bottom
of the screen.
Procedure to upgrade the software of your
portable DVD Portable
For the best performance of your DVD Portable.
Check www.philips.com/support for latest
software upgrades available.
1. Download the latest software from the Philips
support site
2. Unzip the files and then burn it into a CD-ROM to
make a disc for upgrade
3. Power on the Portable DVD Player with AC/DC
adaptor
4. Play CD-ROM for firmware upgrade
Warning: Do not unplug the AC adaptor during
firmware upgrade to prevent flash corrupt of the
set!!
5. Once upgrade is completed, the player is reset
automatically
6. Open the DVD door to remove the disc
Procedure to change region code of your
portable DVD player
1. Power on player and open the DVD door
2. Press [SETUP] by remote control.
3. In Set Up Menu, select <Audio> and press [OK]
4. Press [2], [1], [2], [2], [2], [5], [<], [v]
5. Display will show the Region Code
6. Press Number Key button by remote control to
select the region code
Refer below table for your region code setting
7.
Region code "0" can be used for all regions!
[SETUP] to save and exit your setting
8. Press
9. Power off and power on again to verify if region
code change is done
Remarks:
1. Password is CONFIDENTIAL
2. Region code is printed on product type
plate. Due to DVD legislation region codes
different to assigned region may not be
released