Registering Handsets; Deregistering Handsets - Siemens Gigaset C675 User Manual

Hide thumbs Also See for Gigaset C675:
Table of Contents

Advertisement

First steps
until click sound is heard, means the cover
is fixed properly.
Opening the battery cover
Push downward to open the cover.
Initial charging and discharging of
batteries
If the handset is activated, the flashing
battery icon in the top right of the display
indicates that the batteries are being
charged.
During handset operation, the battery
icon indicates the charge status of the bat-
teries . The correct charge level can only
be displayed if the batteries are first fully
charged and discharged.
¤
To do this, leave the handset in the
charging cradle without interruption
for 15 hours.
¤
Afterwards, remove the handset from
the charging cradle and do not put it
back again until the batteries are fully
discharged.
Please note:
After the first battery charge and discharge
you may replace your handset in its charger
after every call.
Please note:
u
Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and reinsert
them.
u
The batteries may warm up during
charging. This is not dangerous.
8
u
After a while the charge capacity of the
batteries will decrease for technical rea-
sons.

Registering handsets

You can register up to four handsets to
your base.
Registering the handset to the base sta-
tion occurs automatically on first using.
If the automatic register failed, please do
the operations on the handset and on the
base as below.
Operations on the handset
é
¤
Press
.
¤
Select
ADVANCED SET.
ê
firm with
.
¤
Select
REGISTRATION
ê
.
¤
Confirm both messages with
¤
Proceed with the operations on the
base.
Operations on the base
¤
Press and hold the paging key
on the base until beep sounds (approx.
3 sec.).
¤
Input the handset name and confirm
ê
with
.
Once it has been registered successfully,
the handset returns to idle status. The
name and the handset's internal number
is shown in the display e.g.
If fail to register, repeat the procedure.

Deregistering handsets

Please note:
Do not deregister handsets unless necessary!
é
¤
Press
.
¤
Select
ADVANCED SET.
ê
firm with
.
¤
Select
DEREGISTRATION
ê
with
.
with q and con-
and confirm with
ê
.
÷
ç
(
)
INT
1.
with q and con-
and confirm

Advertisement

Table of Contents
loading

Table of Contents