What To Do If - Zanussi ZKG44500 User Manual

• Remove the fuses from the fuse box or deac-
tivate the circuit breaker.
Caution! Put a cloth on the bottom of the
interior of the appliance. It prevents
damage to the lamp glass cover and the cavity.
Always use the same lamp type.
Replacing the lamp at the cavity ceiling:
1. Turn the lamp glass cover counterclock-
wise to remove it.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The lamp does not operate.
The display shows an error code
that is not on this list.
If you cannot find a solution to the problem
yourself, contact your dealer or the service cen-
tre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
www.zanussi.com
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
4. Install the glass cover.
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic cut-out is activa-
ted.
The fuse is released.
The lamp is defective.
There is an electrical fault.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity.
heat-resistant lamp.
Activate the appliance.
Set the clock. Refer to "Setting the
clock".
Make sure that the settings are
correct.
Refer to "Automatic switch-off".
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
Replace the lamp.
• Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and acti-
vate it again.
• If the display shows the error
code again, contact the Cus-
tomer Care Department.
.........................................
.........................................
.........................................
Remedy
19