Traxxas Skully 36064-1 Owner's Manual page 13

INSTALLING THE BATTERY PACK
Place the battery
pack into the battery
compartment of the
model and then place
the battery hold-down
over the posts. Secure
the battery hold-down
with body clips in the
holes in the posts. Do
not connect the battery
pack yet.
The Traxxas High-Current Connector
Your model is equipped with the Traxxas High-
Current Connector. Standard connectors restrict
current flow and are not capable of delivering
the power needed to maximize the output of
the XL-5. The Traxxas connector's gold-plated terminals with large
contact surfaces ensure positive current flow with the least amount of
resistance. Secure, long-lasting, and easy to grip, the Traxxas connector
is engineered to extract all the power your battery has to give.
TRAXXAS TQ 2.4GHz RADIO SYSTEM
SETTING UP THE ANTENNA
The receiver antenna and antenna
tube must be properly installed before
operating your model. Follow these steps
to install the antenna and antenna tube:
1. Slide the antenna wire into the
antenna tube to its full extent. When
fully inserted, the wire should reach
to approximately 1/2 inch below the
tube cap. Do not leave any slack in the
antenna wire.
2. Insert the base of the antenna tube
into the molded post on the chassis.
Take care not to crimp the antenna
wire. Do not bend or kink the antenna
wire! Do not shorten the antenna tube.
See the side bar for more information.
Antenna
Mount
Correct
Battery iD
Your model's included battery
pack is equipped with Traxxas
Battery iD. This exclusive
feature allows Traxxas battery
chargers (sold separately)
to automatically recognize
connected battery packs
and optimize the charge
settings for the battery.
This eliminates the need to
worry over charger settings
and menus for the easiest
and safest charging solution
possible. Visit Traxxas.com to
learn more about this feature
and available Traxxas iD
chargers and batteries.
To prevent loss of radio range,
do not kink or cut the black wire,
do not bend or cut the metal tip,
and do not bend or cut the white
wire at the end of the metal tip.
No No No No
4,5
TRAXXAS • 13