Children of less than 3 years should be kept away unless • continuously supervised. General Safety The appliance and its accessible parts become hot during use. • Do not touch the heating elements. Do not operate the appliance by means of an external timer or • separate remote-control system. www.zanussi.com...
• Obey the installation instruction supplied door or under a window. This prevents hot with the appliance. cookware to fall from the appliance when the • Keep the minimum distance from the other door or the window is opened. appliances and units. www.zanussi.com...
Page 4
Risk of fire and explosion the appliance. Always pull the mains plug. • Use only correct isolation devices: line • Fats and oil when heated can release protecting cut-outs, fuses (screw type fuses flammable vapours. Keep flames or heated www.zanussi.com...
Page 5
• Do not install a flame diffuser on the burner. • Flat the external gas pipes. • The use of a gas cooking appliance results in the production of heat and moisture. Provide good ventilation in the room where the appliance is installed. www.zanussi.com...
Rapid burner Auxiliary burner Control knobs Control knob Symbol Description Symbol Description ignition position / maximum no gas supply / off position gas supply minimum gas supply Daily use Burner overview WARNING! Refer to Safety chapters. A) Burner cap www.zanussi.com...
• To clean the enamelled parts, cap and crown, wash them with warm soapy water 1. Remove the pan supports to easily clean and dry them carefully before you put them the hob. back. www.zanussi.com...
Service Centre and conditions of yourself, contact your dealer or an Authorised guarantee are in the guarantee booklet. Service Centre. Give the data from the rating plate. Make sure, you operated the hob correctly. If not the servicing by a service www.zanussi.com...
For appliances installed in the Republic of same room, B.S. 5440 Part 2 Current Edition, Ireland please refer to NSAI- Domestic Gas should be consulted to determine the requisite Installation I.S. 813 Current Editions and the air vent requirements. ETCI Rules for Electrical Installations. www.zanussi.com...
Page 11
A) End of shaft with nut different from the necessary pressure, you must B) Washer fit an applicable pressure adjuster on the gas C) Elbow supply pipe. Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper. www.zanussi.com...
Page 12
(e.g. your local Electricity D) Cord clamp Board, or a contractor who is on the roll of the E) Blue National Inspection Council for Electrical The wires in the cord are coloured as follows: Installation Contracting [NICEIC]). www.zanussi.com...
Page 13
'L'. It must always be connected to the network phase. There must be no cut or stray strands of wire present. The cord clamp must be correctly attached to the outer sheath. www.zanussi.com...
G31 (3+) 37 mbar = 536 g/h Electric supply: 230 V ~ 50 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp car- tridge fuse Appliance category: II2H3+ Gas connection: R 1/2" Appliance class: www.zanussi.com...
Page 15
Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. www.zanussi.com...