Functional Description - Makita JS1660 Instruction Manual

FUNCTIONAL
DESCRIPTION
1
1. Slide switch
ASSEMBLY
1. Screw
2. Screwdriver
1
A
2
3
1. Center blade
2. Bolt
3. Hex wrench
4. Side blade
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Switch action
004669
CAUTION:
• Before plugging in the tool, always check to see that the slide switch
actuates properly and returns to the "OFF" position when the rear of the
slide switch is depressed.
To start the tool, slide the slide switch toward the "I (ON)" position. For contin-
uous operation, press the front of the slide switch to lock it.
To stop the tool, press the rear of the slide switch, then slide it toward the
"O (OFF)" position.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Adjusting the blade clearance
004692
For JS1660 Only
1
Adjust the clearance between the side blade and the center blade according to
the thickness of the workpiece.
First use a screwdriver to loosen the screw.
Then use the hex wrench to adjust the clearance by tightening or loosening
the bolt. There may be a slight difference between clearances (A) and (B).
2
Check the smaller clearance with the thickness gauge and adjust it.
When using the thickness gauge to adjust the blade clearance, refer to the
table.
Workpiece thickness (mm)
004693
B After adjusting the clearance, tighten the screw securely.
4
Marking on thickness gauge
Less than 0.8
0.8 - 1.3
More than 1.3
006428
0.5
1.0
1.5
5